Coal Mining Water Treatment Flocculant Anionic Polyacrylamide High Molecular Weight

Support and Services:

We offer a wide range of technical support and services for Anionic Polyacrylamide. Our team of experienced professionals is available to answer any questions you may have and provide technical assistance and guidance.

We can also assist with product selection, application development, and process optimization.

Our knowledgeable staff is available to answer your questions and provide technical assistance. We are committed to providing our customers with the best service and support possible.

1. Polyacrylamide can't be put directly into sewage, so dissolve in water before using Polyacrylamide.
2. The dissolved water should be clean water, and without heating, but the temperature can't be cold. The temperature is higher than five degrees Celsius. Otherwise it will be dissolve very slowly.Temperature above 40 degrees Celsius affect the use effect.
3. Notice: Don't use strong acid, strong base, high salt water preparation.
4. The ratio range is recommended to be between 0.1% and 0.3%. For example, 1 liter of water with 1~3g of agents.
5. If because of other reasons, the dispersion is not good, we suggest that you mix a little more sparse.
6. The water is warmer in Summer. Cationic, Anionic Polyacrylamide should be strict for about 1 hour. Nonionic Polyacrylamide should be strict for about 2 hours.
7. The water is cold in Winter, Cationic, Anionic Polyacrylamide should be strict for about one and a half hours. Nonionic Polyacrylamide should be strict for about 3 hours.

• Prepare 0.1% concentration water solution using neutral, desalted water
• Disperse product evenly in stirring water; warming water (below 60°C) accelerates dissolution
• Determine optimal dosage through preliminary testing; adjust water pH before treatment

• Solid product: Packed in inner plastic bags within polypropylene woven bags (25kg per bag)
• Colloidal product: Packed in inner plastic bags within fiber plate drums (50kg or 200kg per drum)
• Store sealed in dry, cool location below 35°C (product is hygroscopic)
• Prevent powder scattering on ground to avoid slipperiness from hygroscopic properties